Husqvarna Rider 11 Workshop Manual page 52

Reparation instructions
Dismantling the cutting unit
Rider 11 and Rider 13 H
1
• Place the Rider on a level surface.
• Apply the brakes by pressing down the pedal
and lock using the pushbutton.
• Lift up the unit using the lifting lever.
• Remove the nose.
!
WARNING!
Wear eye protection and work
gloves when working on the
mowing deck.
2
• Remove the belt adjuster's spring.
• Lift off the belt from the belt pulley.
• Hook on the belt adjuster's spring again.
3
• Hang the belt around the handle.
50
– English
4
Loosen the height setting arm by moving the rear
section upwards. Off-load the arm by pulling the
frame's front section upwards.
5
Pull the handle and unit simultaneously. Release
the handle when the unit has come out a little.
6
Pull out the unit so that it engages in the outer
hooks.
Lower the unit using the lever on the right-hand
side of the driver.