Unpacking The Device; Removing The Control Unit - Sartorius Cubis MCA10202S Series Operating Instructions Manual

Installation
36 Cubis ® MCA Operating Instructions
5.3

Unpacking the Device

Procedure
Lift the device with the styrofoam padding out of the packaging .
t
Place the device in the styrofoam padding on its side .
t
Lift the Styrofoam padding off the device .
t
Place the device on its base .
t
Keep all parts of the original packaging, e .g . to return the device .
t
5.4

Removing the Control Unit

The control unit can be removed . This enables the flexible setup of the display and
control unit at the workplace .
Tool: 1 Torx Allen key, T20
Material: 1 soft support base
Requirements
The weighing pan and all associated components are not placed on the device,
e .g . shield ring, pan support .
Procedure
Turn over the device and place on a soft surface .
t
To loosen the control unit's retainer: Use the Torx Allen key to remove both
t
screws .
Remove the control unit and re-insert both screws into the threaded holes .
t