Table of Contents
Advertisement
Chapter 8: Powering On the Switch
Powering on the GS980EM/10H Switch
Connecting the
PWR300 Power
Supply
98
The GS980EM/10H switch requires an external harness to connect to the
external PWR300 power supply. The GS980EM/10H switch can support
up to three PWR300 power supplies. Each PWR300 power supply
provides 240W PoE power.
To connect the PWR300 power supply to the GS980EM/10H switch:
1. Verify that the PWR300 power supply is powered off.
Warning
Leaving the PWR300 power supply powered on while connecting
the harness to the GS980EM/10H switch could cause an electrical
short that can damage the equipment.
2. Connect one end of the external harness to the GS980EM/10H switch.
Refer to Figure 53.
Figure 53. Connecting the External Harness to the GS980EM/10H Switch
Caution
Do not install the connector at an angle, doing so can bend the
connector pins.
E128
E127
Advertisement
Table of Contents
