Table of Contents
Advertisement
2. Requires the xenon lamp an anode adapter?
Tip:
See supported xenon bulb lamps to know if your lamp requires an anode adapter.
If yes, install the appropriate lamp anode adapter on the anode of the xenon lamp. Fasten the set screw (reference 13 image 4-18)
of the anode adapter with a torque of 2.5Nm (1.84 lbf*ft). Use a torque wrench with a 2.5mm Allen socket. Make sure that there
is full contact between the adapter flat surface and the lamp base.
Image 4-18
If no, make sure that there is no anode adapter installed on the anode of the xenon lamp.
3. Install the anode wire lug (reference 7 image 4-19) on the anode socket of the Lamp House as illustrated. Use an open-end
wrench of 22 mm to hold the first nut (reference 5 image 4-19) while fastening the second nut (reference 9 image 4-19) with a
torque of 25Nm (18.4 lbf*ft) using a torque wrench. Ensure that there is a flat washer (reference 6 & 8 image 4-19) at both sides
of the wire lug (reference 7 image 4-19).
Warning:
A torque of 25Nm (18.4 lbf*ft) must be applied to fasten the nuts. Make sure that there is no tension on the anode
wire of the xenon lamp.
Note: Alter tightening the two nuts, the connector should still be "floating".
Image 4-19
Tip:
Write down the serial number of the xenon lamp. You will need this while updating the lamp parameters after installation
of the xenon lamp. The serial number of the xenon lamp is engraved in the neck of the xenon lamp.
4. Check the cathode connection inside the lamp house. Use an 22 mm open-end wrench to hold the first nut while fastening the
second nut on the rod with a torque of 25Nm (18.4 lbf*ft) using a torque wrench with 22 mm hexagon socket. Ensure that there
is a flat washer at both sides of the wire lug. It's safer to do this check before the xenon lamp is installed to avoid accidental
bumping against the xenon lamp.
Tip:
The cathode socket can easily pulled out from the Lamp House as a whole to perform this check.
Caution:
These cathode connections must be checked with every lamp change!
R59770491 DPXK-32B 17/09/2012
2.5Nm
13
5
6
7
8
9
4. Lamp & Lamp House
25 Nm
35
Advertisement
Table of Contents
