Table of Contents
Advertisement
2. General
4. Installation of a suitable UPS unit or bypass the power in and outlet for the projector electronics. See chapters "Power loop
through to the projector electronics", page 23 or "Connecting a UPS to the projector electronics", page 23.
5. Installation of the xenon lamp in case the xenon lamp is not installed in the lamp house yet. To install the xenon lamp the lamp
house has to be removed from the projector. To install the xenon lamp correctly and in a safe manner, see the detailed step by
step procedures in the chapter "Lamp & Lamp House", page 25.
6. Installation of the lens. First select an appropriate lens which throw ratio covers the screen size and the projector - screen
distance. Then install the lens in the lens holder of the projector. For more information about available lenses, lens selection and
lens installation see chapter "Lens installation", page 49.
7. Installation of the Communicator Touch Panel. See chapter "Communicator Touch Panel", page 65.
8. Alignment of the projected image on the screen. The projector can now be switched on to project its first image (test pattern)
on the screen. Then the image can be aligned with the screen size of the application. Follow the next steps to achieve that:
a) Place the ON/OFF switch of the projector in the "I" position. As a result the projector starts to initialize. The status lights of
the projector lights up GREEN once the projector is initialized.
b) Press the STANDBY button on the local keypad to activate the lamp.
c) Press the DOWSER button on the local keypad to open the dowser of the projector. The dowser is open if the color of the
DOWSER button is GREEN.
d) Press the TEST PATTERN button on the local keypad to project one of the internal test patterns of the projector on the screen.
e) Use the lens ZOOM, SHIFT and FOCUS buttons on the local keypad the match the projected image with the screen. Tilt the
projector in case you can not SHIFT the image completely upon the screen. See "Lens shift, zoom & focus", page 52.
9. Resetting the lamp parameters. The "LAMP INFO" parameters which are stored on the controller board of the projector MUST
be updated after each installation of an xenon lamp inside the lamp house. Neglecting this update will result in poor performance
and short life time of the xenon lamp. See chapter "Resetting the lamp parameters", page 41.
10.Realignment of the xenon lamp in its reflector. For optimal performance of the xenon lamp it is required to realign the lamp
after installation in the lamp house. See "Realignment of the lamp in its reflector (manual Lamp House)", page 44 for more
information.
11. Adjusting the light path. Normally the lens holder and the convergence of the projector is perfectly adjusted at the factory.
Nevertheless, some applications require a readjustment of the lens holder, convergence or both. See procedure "Scheimpflug
adjustment", page 53, to adjust the Scheimpflug and see chapter "Convergence", page 99 to adjust the convergence of the light
path.
12.Registration of the projector. The DPxK-32B is DCI compliant and should be registered by Barco. Therefore, the digital certifi-
cate inside the projector will be used to secure encryption key communication between the projector and the rest of the theatre
system (server and theatre management system). For more info see chapter "Projector registration", page 71.
13.Projection of a digital cinema movie. Apply a single or dual channel SMPTE or DVI source to the input ports of the projector
and start up the projector. See "Source input ports of the DPxK-32B", page 62 and chapter "Starting up", page 69. Use the
Communicator Touch Panel to configure the applied source. See the user guide of the Communicator Touch Panel for more
detailed information.
14
R59770491 DPXK-32B 17/09/2012
Advertisement
Table of Contents
