Table of Contents
Advertisement
3. PHYSICAL INSTALLATION
About this chapter
This chapter describes how the mechanical and electrical set up of the projector has to be done.
Overview
•
Positioning the DPxK-32B at port window
•
Installation of the exhaust system
•
Access to the power connection
•
Power input setup of the DPxK-32B
•
Connecting the DPxK-32B with the power net
•
Power loop through to the projector electronics
•
Connecting a UPS to the projector electronics
3.1
Positioning the DPxK-32B at port window
W
ARNING
General guide lines
•
Use a solid pedestal to put the DPxK-32B on. Ensure that the pedestal can handle the weight of the projector and that all feet
of the projector are captured.
•
The pedestal should be placed in front of the port window wall in a manner that the projector front cover is at a minimum distance
of 20 centimeters from the port window.
Image 3-1
Positioning at port window
Barco offers a pedestal for the DPxK-32B digital projector. This universal pedestal allows a solid and easy
setup of the projector. The universal pedestal has a separate compartment to install the UPS unit (if available)
for the DPxK-32B digital projector. Futhermore, the universal pedestal contains a standard 19" rack to build
in the projector peripherals like alternative content switchers (e.g. ACS-2048).
Necessary tools
•
14 mm wrench
•
17 mm wrench
Projector centering
1. If the projector is standalone in front of the port window, center the projector with the theatre screen (see ref A image 3-2).
R59770491 DPXK-32B 17/09/2012
:
The installation of the DPxK-32B requires at least 4 persons.
20 cm
3. Physical installation
15
Advertisement
Table of Contents
