F Industrial Truck Maintenance; Operational Safety And Environmental Protection; Maintenance Safety Regulations - Jungheinrich ECE 220 Operating Instructions Manual

F Industrial Truck Maintenance

1

Operational Safety and Environmental Protection

The checks and servicing operations contained in this chapter must be performed in
accordance with the intervals as indicated in the servicing checklists.
F
Any modification to the forklift truck assemblies, in particular the safety mechanisms,
is prohibited. The operational speeds of the truck must not be changed under any
circumstances.
M
Only original spare parts have been certified by our quality assurance department. To
ensure safe and reliable operation of the truck, use only the manufacturer's spare
parts. Used parts, oils and fuels must be disposed of in accordance with the relevant
environmental protection regulations. Use the manufacturer's oil department for oil
changes.
Upon completion of inspection and servicing, the tasks contained in the
"Recommissioning" section must be performed (see chapter F).
2

Maintenance Safety Regulations

Maintenance personnel: The fork lift truck must only be serviced and maintained by
trained personnel of the manufacturer. The manufacturer's service department has
field technicians specially trained for these tasks. We therefore recommend a
maintenance contract with the manufacturer's local service centre.
Lifting and jacking up: When an industrial truck is to be lifted, the lifting gear must
only be secured to the points specially provided for this purpose. When jacking up the
truck, take appropriate measures to prevent the truck from slipping or tipping over
(e.g. wedges, wooden blocks). You may only work underneath a raised load handler
if it is supported by a sufficiently strong chain.
Cleaning: Do not use flammable liquids to clean the industrial truck. Prior to cleaning,
implement all necessary safety measures to prevent sparking (e.g. through short
circuits). For battery-operated trucks, the battery connector must be removed. Only
use weak indraft, weak compressed air and non-conducting, antistatic brushes to
clean electric or electronic assemblies.
M
If the truck is to be cleaned with a water jet or a high-pressure cleaner, all electrical
and electronic components must be carefully covered beforehand as moisture can
cause malfunctions.
Do not clean with pressurised water.
After cleaning the truck, carry out the activities detailed in the "Recommissioning"
section.
F 1