Travel Parameters - Jungheinrich ECE 220 Operating Instructions Manual

5.5

Travel parameters

Z
For trucks without a display instrument (CANDIS (o)) the code lock parameters can
only be set by the manufacturer's service department.
The following example shows the parameter setting for the acceleration of travel
program 1 (parameter 101).
Acceleration example
Enter the three digit parameter number (101) and confirm with the Set key (22).
current setting is
displayed
– Check the LC display of the display instrument (CANDIS (o)) (parameter number
and current parameter value are displayed).
Z
If there is no input for approx. 5 seconds, the display switches back to showing the
operating hours.
F
If you require a different parameter number than the one displayed, you must wait
until the operating hours are displayed again.
Enter or change the parameter value according to the parameter list.
changed
setting is
displayed
Check the LC display of the indicator instrument (CANDIS (o)) (confirm with the Set
key (22)).
– The LED (23) of the o key (26) switches briefly to continuously lit and starts
flashing again after approx. 2 seconds.
Z
If the entry is incorrect, the LED (21) of the o key (26) goes red. If you enter the
parameter number again the setting can be entered or changed.
Repeat the process to enter more parameters as soon as the LED (21) of the o key
(26) flashes. To complete your entry, press the o key (26).
Display instrument
(CANDIS)
101 6
Display instrument
(CANDIS)
101 8
Display instrument
(CANDIS)
Parameter Para-
number meter
setting
LED (21) LED (23)
o key
Key 1
Green Off
Flashing
LED (21) LED (23)
o key
Key 1
Green Off
Flashing
LED (21) LED (23)
o key
Key 1
LED (24) LED (25)
Key 2 Key 3
Off Off
LED (24) LED (25)
Key 2 Key 3
Off Off
LED (24) LED (25)
Key 2 Key 3
E 25