Adjusting The Riding Sag - Husqvarna TC 85 2020 Owner's Manual

10 TUNING THE CHASSIS
10.11
40
402659-10

Adjusting the riding sag

B00292-10
Main work
–
Measure the full spring length while it is under tension and
note down the value.
–
1
Loosen screw .
–
2
Turn adjusting ring until the spring is no longer under ten-
sion.
Hook wrench (90129051000)
–
Measure the total spring length while the spring is not under
tension.
–
Tighten the spring by turning adjusting ring
A
dimension .
Guideline
Spring preload
Info
The spring preload is the difference between the
relaxed spring length and the tensioned spring length.
Depending on the static sag and/or the riding sag, it
may be necessary to increase or decrease the spring
preload.
–
1
Tighten screw .
Guideline
Screw, shock
absorber adjusting
ring
Finishing work
–
Install the shock absorber.
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
Main work
–
Choose and mount a suitable spring.
Guideline
Spring rate
Weight of rider: < 45 kg
(< 99 lb.)
Weight of rider: 45 ...
55 kg (99 ... 121 lb.)
Weight of rider: > 55 kg
(> 121 lb.)
2
to specified
11 mm (0.43 in)
M5 5 Nm (3.7 lbf ft)
( p. 57)
p. 46)
p. 46)
( p. 57)
35 N/mm (200 lb/in)
40 N/mm (228 lb/in)
45 N/mm (257 lb/in)