10 TUNING THE CHASSIS
42
Main work
–
Remove protection cap
–
Push together fork airpump
Fork airpump (79412966100)
Info
The fork airpump is included as part of the motorcy-
cle's accessory pack.
S03413-10
–
Connect the fork airpump to the left fork leg.
The fork pump airpump switches on automatically.
A little air escapes from the fork leg when connecting.
Info
This is due to the volume of the hose and not due to a
defect in the fork airpump or the fork.
Observe the accompanying instructions for Husq-
varna Motorcycles accessories.
–
Adjust the air pressure as specified.
Guideline
Air pressure
Changing the air pressure in
steps of
Minimum air pressure
Maximum air pressure
Info
Never adjust the air pressure to a value outside the
stated range.
–
Disconnect the fork airpump from the left fork leg.
When disconnecting, excess pressure will escape from
the hose – the fork leg does not lose any air.
The fork pump airpump switches off automatically after
80 seconds.
–
Mount the protection cap.
Info
Only mount the protection cap by hand.
Finishing work
–
Remove the motorcycle from the lift stand. (
1
.
2
fully.
5 bar (73 psi)
0.2 bar (3 psi)
4 bar (58 psi)
8 bar (116 psi)
p. 46)