SERVICE WORK ON THE CHASSIS 11
–
Clean and grease the wheel spindle.
Long-life grease (
–
Position front wheel.
–
Insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
E00247-13
–
Position the brake caliper with the spacers.
–
Mount screws
Guideline
Screw, front
brake caliper
–
Position the brake line and the clamp. Mount and tighten
bm
screws
.
–
Operate the hand brake lever several times until the brake
M01562-11
linings are seated correctly against the brake disc. Secure the
hand brake lever in the activated position.
The brake caliper straightens.
–
Tighten screws
Guideline
Screw, front
brake caliper
–
Remove the locking piece of the hand brake lever.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Finishing work
–
Install front fender. (
–
Install the start number plate. (
–
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
–
Position handlebar cushion and secure with a cable tie.
p. 127)
bk
.
M20x1.5
35 Nm (25.8 lbf ft)
bl
, but do not tighten yet.
M8
25 Nm (18.4 lbf ft)
bl
.
M8
25 Nm (18.4 lbf ft)
bn
.
M8
15 Nm (11.1 lbf ft)
p. 57)
p. 55)
p. 54)
®
Loctite
243™
Loctite
®
243™
p. 46)
p. 46)
53