Mircom TX3 Series Programming Manual page 17

2.7.1 Tone/Pulse mode
Note:
To access the Tone/Pulse option screen
1.
2.
2.7.2 Line Type
The Line Type function defines each of the 5 telephone lines as ADC, NSL or not
used. By default is line 1 is ADC and lines 2 to 5 as unused.
To define the line type operation
1.
2.
3.
4.
5.
TX3 Telephone Access System Programming Manual
Version 2.7
LT-979 Copyright 2018
Although this option appears on the front panel, it is not
configurable. The telephone always operates in tone mode. Pulse
dialing is not available.
Press the arrow key to scroll to "Tone/Pulse mode" and press the telephone
key. The tone/pulse selection appears.
Press the info key to return to the previous menu.
Press the arrow key to scroll to "Line Type" and press the telephone key.
The line selection appears.
Using the down arrow key to select L-1, and press the telephone (enter)
key. The line type selection appears.
Use the '*" and or "#" key to make a selection.
Press the telephone key to enter the selection.
Press the info key to return to the previous menu.
Line Type
L-1
L-2
L-3
Select Line Type
[ x ] ADC Type
[ ] NSL Type
[ ] Unused
Configuration
17