Installing Logs - Procom FBD400T-C User Manual

INSTALLING LOGS

WARNING: Failure to position the
parts in accordance with these diagrams or
failure to use only parts may result in
property damage or personal injury.
CAUTION: After
periodically thereafter, check to ensure that
no flame comes in contact with any log.
With the heater set to high, check to see if
flames contact any log. If so, reposition logs
according to the log installation instructions
in this manual. Flames contacting logs will
create soot.
All logs
STEP 2: Install log 2 onto the two slots in left plate.
And install log 3 onto the two slots in right plate.
STEP 4: Insert the recessed holes bottom of log 5
onto the pins on log 2 and 4. Insert the recessed
holes bottom of log 6 onto the pins on log 1 and 3.
installation and
IMPORTANT: Make sure log does not cover any burner ports
(see Figure 13). It is very important. To install the logs exactly as
instructed. Do not modify logs. Only use logs supplied wall heater.
Figure 13-Installing Log Set
STEP 1: Install log 1 onto the two slots in middle plate.
STEP 3: Install log 4 onto the two slots in front plate.
15