Off Operation; Thermostat Function; To Change The Set Temperature; Remote Control Operation Notes - Procom FBD400T-C User Manual

OFF OPERATION

Press the OFF key and the appliance flame will shut off.
During this time the LCD screen will show OF (figure 23).
After 3 seconds the LCD screen will default to display room
temperature and the wood TEMP will show (figure 24).

THERMOSTAT FUNCTION

SETTING DESIRED ROOM TEMPERATURE
This remote control system can control the thermostat when the
transmitter is in the THERMO mode (The word ROOM must be
displayed on the screen). To set the THERMO MODE and
desired room temperature, Press the MODE key until the LCD
screen shows the word ROOM. Then the remote is in the
thermostatic mode. Press and hold the SET key until the
desired set temperature is reached. (By pressing and holding
the set key the LCD screen set numbers will increase from 45° to 99° and then restart over at 45°) Next release the
SET key. The LCD screen will display the set temperature for 3 seconds and the LCD screen will flash the set
temperature for 3 seconds. Then the LCD screen will default to display the room temperature.

TO CHANGE THE SET TEMPERATURE

Press and hold the SET key until the desired set temperature
is reached. (By pressing and holding the set key the LCD screen
set numbers will increase from 45° to 99° then restart over at 45°).
Next release the SET key. The LCD screen will display the
set temperature for 3 seconds. Then will flash the set temperature
for 3 seconds. Then the LCD screen will default to display the room
temperature. Press the MODE key to disengage the thermo mode.
The word ROOM on the LCD screen will not show when the thermo is not in operation.
NOTE: The highest SET temperature is 99°F (32 °C) and the lowest temperature is 45°F (6°C).

REMOTE CONTROL OPERATION NOTES:

The Thermo Feature on the transmitter operates the appliance whenever the ROOM TEMPERATURE varies a certain
number of degrees from the SET TEMPERATURE.
This variation is called the "SWING" or TEMPERATURE DIFFERENTIAL. The normal operating cycle of an appliance
may be -4 times per hour depending on how well the room or home is insulated from the cold or drafts. The factory
setting for the "swing number" is 2. This represents a temperature variation of +/-2°F (1°C) between SET temperatures
and ROOM temperature, which determines when the fireplace will be activated. The transmitter has ON and OFF manual
functions that are activated by pressing either button on the face of the transmitter. When a button on the transmitter is
pressed the word ON or OF will appear on the LCD screen to show while the signal is being sent. Upon initial use, there
may be a delay of three seconds before the remote receiver will respond to the transmitter. This is part of the system's
design.
Figure 23
22
Figure 24
Figure 25
Figure 26