Checking Copies Before Printing; Copy) - Sharp MX-2300G Manual

CHECKING COPIES BEFORE PRINTING

(Proof Copy)
This feature prints only one set of copies, regardless of how many sets have been specified. After the first set is checked
for errors, the remaining sets can be printed. Normally it is necessary to re-scan the original each time changes to
settings are required. However, this feature makes it possible to change settings for the scanned original without
scanning it again, allowing you perform copying more efficiently.
5 sets of copies are specified
1
Full Colour
Colour Mode
Original
Job Detail
Settings
2
Auto
Exposure
100%
Copy Ratio
Ready to scan for copy.
Full Colour
Colour Mode
Job Detail
3
Settings
Auto
Exposure
100%
Copy Ratio
1 set of copies is printed
2-Sided Copy
Auto Auto A4
Paper Select
Plain
A4
Special Modes
Special Modes
2-Sided Copy
Original A4
Plain
A4
Special Modes
A4
1.
A4R
2.
B4
3.
A3
4.
If OK
The remaining 4 sets are printed
Adjust the
settings
1 set is printed after the
settings are adjusted
Place the original.
Place the original face up in the document feeder tray, or face
down on the document glass.
Select copy settings.
Output
File
Quick File
Touch the [Special Modes] key.
0
Output
File
Quick File
151
If OK
The remaining 4 sets are printed