Storing Copy Operations (Job Programs) - Sharp MX-2300G Manual

STORING COPY OPERATIONS (Job Programs)

A job program is a group of copy settings stored together. When copy settings are stored in a job program, the settings
can be called up and used for a copy job by means of a simple operation.
For example, suppose A3 (11" x 17") size CAD drawings are copied once a month for archive purposes using the
following settings:
(1) The A3 (11" x 17") size CAD drawings are reduced to A4 (8-1/2" x 11") size.
(2) The drawings have fine lines that do not show clearly, and thus a dark exposure setting (level 4) is used.
(3) To reduce paper use by a half, 2-sided copying is used.
(4) Margin shift is used so that holes can be punched for filing.
When a job program is not stored
Set A3 (11" x 17") to A4 (8-1/2" x 11") reduction
Change the exposure setting
Select 2-sided copying
Select margin shift
Select punch hole settings
Press the [COLOUR START] key or the [BLACK & WHITE
START] key.
Considerable time is required to copy the drawings each
month because the above settings must be selected.
In addition, mistakes are occasionally made when selecting
the settings, so some copies must be redone.
• Up to 48 job programs can be stored. The job programs are retained even if an interruption occurs in the power supply.
• Job programs can also be stored in the Web pages. Click [Job Program Registration] and then [Copier] in the Web page
menu to store a job program.
A3 (11" x 17") size CAD drawings
or
Copies
When a job program is stored
Press the [Program] key (
Job Programs
Press program number.
1
5
Recall
Touch the stored program key.
Press the [COLOUR START] key or the [BLACK & WHITE
START] key.
The settings are stored in a job program, so they can be
selected by the touch of a key. This is simple and takes no time.
In addition, the settings are all stored so there are no chances for
mistakes, and thus no need to redo copies due to setting mistakes.
159
).
2 3 4
6 7 8
Store/Delete
or
Exit
1/6