Sharp MX-2300G Manual page 63

Special Modes
Margin Shift
3
Pamphlet Copy
(1)
Special Modes
Erase
4
Edge Centre
Erase Erase
5
To cancel scanning of the original and copying...
Press the [STOP] key (
When the erase function is used, erase takes place at the edges of the original image. If you also use a ratio setting, the
erase width will change according to the selected ratio. For example, if the erase width setting is 20 mm (1") and the copy is
reduced to 50%, the erase width will be 10 mm (1/2").
To cancel the erase setting...
Touch the [Cancel] key in the screen of step 4.
System Settings (Administrator): Erase Width Adjustment
The default erase width can be set from 0 mm to 20 mm (0" to 1"). The factory default setting is "10 mm (1/2")".
Dual Page
Erase
Copy
Job Tandem
Build Copy
(2)
Cancel
Edge
Edge+Centre
Erase
(0 20)
10
mm
or
).
Touch the [Erase] key.
OK
1/4
Select the erase settings.
(3)
(1) Touch the desired erase mode.
OK
Select one of the three positions.
OK
(2) Set the erasure width with
0 mm to 20 mm (0" to 1") can be entered.
(3) Touch the [OK] key.
You will return to the base screen of copy mode.
Press the [COLOUR START] key
( ) or the [BLACK & WHITE
START] key (
Copying will begin.
• If the originals were placed in the document feeder tray, the
originals are copied.
• If you are using the document glass, copy each page one
page at a time. If you are using the sort function or other
function that requires all originals to be scanned before the
copies are printed, you must use the same [START] key that
you used to scan the first original to scan each of the
remaining originals.
62
.
).