Adjustment - Omron EJ1 User Manual

Control Linked to a Host Device
PLC
3-3-4

Adjustment

44
Note (1) Displayed when the CX-Thermo's View Mode is set to Expert Mode.
(2) The parameters for programless settings 20 and higher can be displayed
by switching the View Mode to Expert Mode.
Note • The Programmable Terminal and E58-CIFQ1 Connecting Cable cannot
be connected at the same time.
• When connecting the cable for the Support Software to an EJ1C-EDU
End Unit, either turn OFF the Programmable Terminal's power supply or
switch the Programmable Terminal's screen to the system menu.
The following example settings are for communications with port 2 of a CJ1W-
SCU41 Serial Communications Unit.
Port 2: User/custom settings
Port 2: Serial communications mode
Port 2: Baud rate
Port 2: NT Link (1:N) maximum unit number
Execute autotuning (AT) to make the PID adjustments.
Refer to 4-3-8 Tuning for details.
Section 3-3
Custom settings
NT Link (1:N)
High-speed
0