Adjustment Level - Omron E5GN Instructions Manual

E5GN
Initial Setting Level
Input type
Scaling upper limit
Scaling lower limit
Decimal point
Number of displayed digits
Temperature unit
Set point upper limit
Set point lower limit
PID / ON/OFF
Select the control system.
Standard/heating and cooling
1
ST Self-tuning
Control period (heat)
Control period (cool)
1
Direct/reverse operation
Alarm 1 type
Alarm 2 type
1
Move to advanced function
setting level
Note: 1. For E5CN only.
For analog input
(Input type: 16)
0- to 50-mV setting
 : °C
 : °F
Limit the set point.
 : ON/OFF control
 : PID control
 : Standard
 : Heating/cooling
 : Enabled
 : Disabled
Set the pulse
output cycle.
 : Reverse
 : Direct
Select the alarm
mode.

Adjustment Level

AT execute/cancel
Communications writing
2 Heater current
value monitor
Heater burnout
2
detection
Set point 0
Set point 1
Set point 2
Set point 3
Temperature input shift
Upper-limit temperature
input shift value
Lower-limit temperature
input shift value
Proportional band
Integral time
Derivative time
2
Cooling coefficient
2
Dead band
Manual reset value
Hysteresis (heat)
Hysteresis (cool)
2
Note: 2. For E5CN only.
E5GN
Auto-tuning
 : Enabled
 : Disabled
HBA
function
multi-SP functions
are for E5CN only.
1-point shift
2-point shift
P
PID settings
I
D
Used in heating and
cooling control
Clear the offset during
stabilization of P or PD
control.
Set hysteresis.