ProSoft Technology AN-X-MOD User Manual page 12

Table of Contents

Advertisement

8
Page
AN-X-MOD (Master)
IMPORTANT!
IMPORTANT!
IMPORTANT!
If AN-X does not find a DHCP server within about three minutes of
starting up, it reverts to a temporary static IP address of 192.168.0.41 If
AN-X is using this temporary IP address, it repeatedly flashes the SYS
LED red three times followed by a pause. If your computer is on the
same subnet, you can use the web interface to change the IP address.
Use this temporary IP address only for initial setup of AN-X. AN-X will
not function for its intended purpose at the temporary IP address.
If you are using multiple AN-X modules, configure them one at a time,
especially if there is no DHCP server on the network, since they will all
revert to the same temporary IP address when they fail to find a DHCP
server.
If you are connecting AN-X to an existing Ethernet network, consult the
network administrator to obtain a static IP address for AN-X and to
obtain information about how you should configure AN-X.
The AN-X must be on the local Ethernet (same subnet as your computer)
when you set its IP address.
You configure the Ethernet properties using the Windows utility AnxInit
supplied with AN-X or the AN-X web interface.
Use the Configuration/AN-X IP Settings command to start the AN-X IP
configuration wizard, which takes you step by step through the IP
configuration process.
Step 1
In step 1, you identify the AN-X you are configuring.
November 2011

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AN-X-MOD and is the answer not in the manual?

This manual is also suitable for:

An-x-mod master

Table of Contents