Synectix EZ VMS Lite User Manual page 25

EZ VMS Lite
The hook flash duration is programmable in steps of 50 msec (0.05 sec) from 0 to 2.45
seconds. If the Hook Flash duration is too short, the caller hears the digits being dialed by
the PBX when the call is to be transferred to the extension. If the Hook Flash duration is
too long, the call is disconnected.
The valid range is from 01 to 49, where Hook flash duration = nn x 0.05 sec. The Default
value = 06 (300 ms)
1.5.1.2
This value determines the delay period between the unit going off hook and the start of
the message playing.
Enter a value in the range 0 to 9 where n x 0.2 sec gives the total delay period. The
Default value = 5.
If this value is too small, the caller may miss the first few syllables or the first word of the
main greeting.
1.5.1.3
This value determines the delay period after hook flashing and before dialing the digits
for transferring a call.
Enter a value in the range 0 to 9 where n x 0.5 sec gives the total delay period. Default
value = 2
If this value is too small, the PBX will miss one or more of the digits dialed by the unit for
transferring the call.
1.5.1.4
The available options are:

Tone

Pulse

Long Tone
EZ VMS Lite announces the current dialing mode by numbers. Enter new value in
numbers to indicate tone, pulse or long tone dialing mode. Default value is 1 (Tone).
1.5.1.5
The Message Waiting Lamp (MWL) is normally available on most digital phone
instruments and some analog phones. This lamp may be made to glow on or off by
sending an appropriate string to the PBX and is usually made to flash when a mailbox-
owner gets a new message.
EZ VMS Lite first announces the current status (enabled/disabled) for the MWL followed
by the prompt:

Press 1 to Enable Message Waiting Lamp

Press 2 to Disable Message Waiting Lamp
24
Length of entry = fixed 2 digits.
Off-Hook to Message Delay:
Delay after Hook-flash:
Dialing Mode:
Message Waiting Lamp Parameters: