Erasing Numbers And Names - Epson PriorityFax 3000 Owner's Manual

Using speed dial faxing
Erasing Numbers
and Names
Erasing Numbers
After you have registered the speed dial numbers, you can send
a fax to any of those numbers in just three steps:
Insert the document face down in the feeder. The ready display
appears.
Press S. DIAL
Press the two numbers on the keypad corresponding to the
number you want to
If you have not registered a number for the button you pressed,
the message NOT REGISTERED appears.
you
When press START, the fax machine starts
page and starts dialing.
If the receiver's fax machine answers, the PriorityFax starts
transmission automatically. If the receiver's fax machine is busy,
the Priorityfax automatically enters the automatic redial mode.
You can also use the speed dial buttons for dialing after pressing
or lifting the handset. (This is manual sending.) In this
SPKR
to
case, you need press START after
receiver's fax machine, and it will not enter the automatic redial
mode.
If you wish to erase
use the instructions in this section.
To erase a number follow these steps:
If not already shown, bring up the number
Make sure the cursor is under the first number of the item you
wish to erase.
three times to erase the number.
Press PAUSE
You may now enter
If you would rather return to the date/time display without
entering a new number, press
and press
use START.
hearing the fax tone from the
fax number, a telephone number, or a name,
a
new number.
a
SET three times.
Using the PriorityFax
feeding the first
the display.
on
2-25