The unit will output a long beep and the “ERROR” LED will blink, indicating the unit is in maintenance mode. If the unit does not enter the maintenance mode call Epson Product Support at 213- 539 - 9955 for assistance.
F. The functions in Table 1 marked “NOT USED” are either not available or require specialized equipment. They should only be accessed by an authorized Epson Customer Care Center. EEPROM PARAMETER INITIALIZATION Function Sets the EEPROM memory content, user switch data, and soft switch data to the factory default settings.
PSB No: P-0071 Page: 3 of 7 TRANSMISSION VERIFICATION REPORT 1. To set the Transmission Verification Report to “ON”, enter the initial Press the “START/COPY’ key 7 times and then maintenance mode. press the “FINE/PHOTO” key one time. To set the Transmission Verification Report to “OFF”, enter the initial maintenance mode.
PSB No: P-0071 Page: 4 of 7 SECOND LEVEL SOFT SWlTCH FUNCTION DESCRIPTIONS TABLE 2 - Switch 1: Overseas communication mode (reception) Setting switch 1 to a “1” allows the unit to acknowledge the 1100 Hz signal that suppresses echoes, instead of a 2100 Hz which disables the echo suppressor (ES).
PSB No: P-0071 Page: 5 of 7 TABLE - Switches 3 & 4: Modem Equalizer These switches are used for setting the modem equalizer to compensate for line loss. The function section of Table 4 lists the relationship between the line loss and the appropriate switch setting that compensates for that loss.
PSB No: P-0071 Page: 6 of 7 To enter Inttlal Halntenance Hold down the Mode, FINE/PHOTO START/COPY buttons while aoDlYlng Dower. Initial Maintenance Mode Sets second digit to 1 Press FINE/PHOTO 1 time Sets first digit to 0 Press START/COPY 10 times Completes code entry...
PSB No: P-0071 Page: 7 of 7 Switch Ructch ' Dorcriptim Rotting nuler Fuwxion O V E R S E A S -ICATlOR 0 ‘Off RODE (Rraption) DIRECT CONYECTIOll #OE 1 S-8 1 ROT USED Suitch' Faction Naber Dercriptim EEPR# PMMETER &itch lYfTlAlIzATlw BUCriptim...
EPSON EPSON AMERICA, INC. Product Support Bulletin Subject: PriorityFax 1000 Equipment Error Codes Date: 3/7/90 PSB No: P-0061 Page: 1 of 3 Originator: VB This product support bulletin explains the procedure for reading and interpreting PriorityFax 1000 (PF1000) error codes.
PSB No: P-0061 Page: 2 of 3 For example, if a document is being sent and is not detected by document sensor 2, the PF1000 will go into error mode. Simultaneously pressing and holding the FINE/PHOTO and the START/COPY buttons until the buzzer stops sounding, sets the PF1000 into an error code display mode.
PSB No: P-0061 Page: 3 of 3 Table 1 EQUIPMENT ERROR CODES *SD = SENDING DOCUMENT LED 1 .STATE *RD = RECEIVING DOCUMENT LED *FN = FINE LED *PH = PHOTO LED RDIFN(PH Error Codes 1 0 0 0 1 Paper jam error 1 0 0 0 1 Auto cutter jam error...