Installing The Output Tray And Paper Rest - Epson PriorityFax 3000 Owner's Manual

Installing the Output
Tray and
Paper Rest
Installing
the output
There are two types of paper holders for the PriorityFax: the
output tray for holding documents sent to or copied by you, and
the paper rest for holding documents you have just sent to others.
tray
The larger of the two paper holders, the output tray, receives
incoming and copied documents. You can position the output tray
at a 90° angle to the fax machine at the front edge of the table you
are using, so that incoming or copied documents fall directly into
the output tray.
Note:
To install the output tray base and the output tray, follow these
steps:
Place the output tray base on the table in front of you, with the
tabs on the output tray base pointing away from you. Then insert
the wire output tray paper guide into the holes on either side of
the output tray base so that the bend in the wire paper guide
points toward you, as shown in the following illustration.
Using the output tray is optional. If you install only the
output tray base, you can collect incoming or copied
documents on the table or other surface you are using for
the fax machine.
Setting Up the PriorityFax
1-5