Table of Contents
Advertisement
1.3 Removal of Protective Paper
The FX-80 is provided with a protective paper inserted between the inner and outer
paper guides to protect the paper end detector from damage due to shocks or
vibrations during transportation. Before using the printer, be sure to remove this
paper.
If
the FX-80 is to be reshipped, remember to return the paper to the original
position.
<Repacking Steps>
Repacking can be carried out by following the above steps in the reverse order.
(Repacking: Shipment for repair, storage, etc.)
NOTE:
It is recommended that all original packing materials be saved for reuse in case the
FX-80 requires reshipment in the future.
1.4 Operation Site Selection
1.
The FX-80 should be installed on a fiat, firm surface with enough room as shown
below.
2. Care should be exercised in locating the FX-80 in areas where it will not be
exposed to direct sunlight or where the environment contains grease or dust.
3. The FX-80 should not be located in the vicinity of noise generating equipment or
heat generating equipment.
4. Do not subject the FX-80 to temperatures below 5°C (41°F) or above 35°C
(95°F) during operation. Also avoid sudden changes in temperature and
extreme shock.
Computer
Flat, firm surface
-
Laying Printer on Flat,
Firm
Surface
-
1-2
Advertisement
Table of Contents
