Initial Commissioning - Ahlborn ALMEMO 2590-2A Operating Instructions Manual

INITIAL COMMISSIONING

6.
Sensor connection Connect the sensor to any socket M0 to M3 (1); see Ch 8.
Power supply
To switch ON
Automatic display of last measuring menu see Ch 11.
To call up menu selection
press key(s) :
To activate / deactivate display illumination :
To select measuring menu
press key(s) :
To call up the menu press key(s) :
To select a measuring point (see 11.1.1)
press key(s) :
All channels on the connector or those functions needed
for measured value calculation are displayed.
To call up the functions menu list :
To select the functions menu (see 9.4)
press key(s) :
To call up the menu press key(s) :
e.g. Functions menu Data logger functions :
(only possible if storage medium available)
Once-only saving : see 12.5.4
Cyclic saving : see 12.5.5
cycle timer
To select
Entering the cycle (hh:mm:ss)
To set the output format :
To terminate programming mode :
To start a measuring operation
To stop a measuring operation
Memory output via interface to computer :
- Connect peripheral device via data cable to socket A1 (2); see Manual, Section 5.2
free memory
To select
Output memory ; see 12.5.7
Clear the memory ; see 12.5.7

Important keys :
press key(s) :
16
via batteries or mains adapter to DC (3) ; see 7.1, 7.2
press the
ON / PROG key
<MENU>
Sensor display
<F>
<M>
<F>
< MANU >
press key(s) :
PROG
PROG
< FORM>
< ESC>
<START>
<STOP>
press key(s) :
< PMEM>
< CMEM >
To return as far back as menu selection,
◄ ..., To go to the measuring menu :
(6) ; see 7.5
<*ON>
; see 9.1
...
: ▲ / ▼
► or PROG
...
: ▲ / ▼
< FCT >
...
: ▲ / ▼
► or PROG
, ▲ / ▼ ...
, ▲ , PROG
..
...
,
PROG 
or command ´P04´ from the computer
or command ´C04´ from the computer
...
< M◄◄ >