Initial Commissioning - Ahlborn ALMEMO 5690-1M Operating Instructions Manual

5.

INITIAL COMMISSIONING

1. Sensor connection : Plug in sensor at sockets M0 to Mxx (2c); see Sec. 7.
2. Power supply :
3. Switching on :
4. Device configuration by PC via the interface :
Connect computer via interface cable to socket A1 (2f); see Manual 5.2.
Activate the software, e.g. the supplied AMR-Control.
Identify the device by means of <Search network>,
If the device is not found select <Setup interface>.
Set the COM interface and baud rate to 9600 baud; (see Manual 6.1.1.)
<Update list> <Program device>
Input "cycle" for automatic measuring point scan; see Manual 6.5.2.
Activate "With memory" to save (only with option S or memory connector)
if necessary "Accept date and time-of-day from PC"; see Manual 6.2.8.
Program the output format; see Manual 6.5.5 and 6.6.1.
"Table" for MS-Excel / "List" or "Columns" for text editor
5. Measured data acquisition from PC without saving in device :
Activate <File - terminal>; see Manual 6.1.3.
<Open file - terminal - log>, enter file name, "Save"
Start measuring operation by the "Start" button or the START/ STOP key;
Stop measuring operation by the "Stop" button or the START/ STOP key.
<Close file - terminal log>
Activate file e.g. from MS-Excel and import using ";" as separator;
6. Saving meas. values in the device : (only with option S or memory connector)
Activate <Measured value memory>.
If necessary "Clear memory" "Execute"; see Manual 6.9.3.
For long-term recording (cycle > 2 minutes) Activate sleep mode; s. Sec.
10.2.1.
"Start saving to memory" immediately or
start measuring operation on site by pressing the START/ STOP key.
or in <Program device> enter measuring operation "Start date /
time"´and ´End date / time"; see Manual 6.6.2.
At the end of the meas. operation stop recording by the START/ STOP key.
Transferring data from memory to the computer
If you are using a memory connector remove the memory card and transfer
via a USB reader to the PC (see Manual 6.9.4.2) or
reconnect the computer via the interface cable at socket A1 (2f); see above.
In AMR-Control activate <Measured value memory>.
Click on "Read out complete memory".
Set "Format"; see above.
Read out "Execute", enter file name, "Save"; see Manual 6.9.3.
Activate file e.g. from MS-Excel and import using ";" as separator;
Connect mains adapter at socket DC (2g); s. Sec. 6.1.
Press the ON key (2e); see Section 6.5.
13