Christie Captiva Touch User Manual page 26

TroUBlesHooTiNg
Q6 Auto Calibration and Auto Touch Area Setting both failed?
A:
1. Check the "Ceiling Mount" OSD setting first. The interactive
When projector OSD message is shown, this may result in failure
to Auto Calibration and Auto Touch Area Setting. Wait until OSD
message is gone before performing Auto Calibration and Auto
Touch Area Setting.
Follow the troubleshooting steps below to perform Auto Calibration
and Auto Touch Area Setting again.
a. Exit all software applications.
b. Reduce ambient light.
c. Do not obstruct or shake lens while setting up Calibration
d. Check if the projection image is clear. If not, adjust focus to
e. If the "Auto Touch Area Setting failed" or "Auto Calibration
2. Check Laser Power Mode selection Lower brightness (ECO
26
function supports Ceiling Mode only
sharpen the image.
failed" message pops up on screen again, switch to Manual
Mode to do Touch Area Setting and Calibration.
mode) may affect both Auto Touch Area Setting and Auto
Calibration. Switch to Normal mode to complete Touch Area
Setting and Calibration.
Configuration
Aspect Ratio Auto
Phase
Clock
H. Position
V. Position
Digital Zoom
V. Keystone
Front Ceiling
Orientation
Select Enter
VGA
1280X720 60Hz
Back
Captiva Touch User Manual
020-000838-01 Rev. 1 (08-2015)