Advertisement
3. CARE AND MAINTENANCE
3.1 SAFETY
DANGER
DANGER TO LIFE DUE TO WRONG MAINTENANCE OF THE SHOCK!
Incorrect maintenance or assembly of the shock can lead to incorrect function!
• Maintenance and assembly may only be done by a skilled professional.
• In case of any doubt, contact a DT Swiss service center.
• Only use original spare parts.
3.2 CARE
The following care and cleaning instructions must be observed:
•
Clean the shock with a damp cloth after each ride. Remove dirt accumulations in the area of the wiper
seal.
•
Never use aggressive cleaners that damage the wiper seal.
•
Never use high pressure cleaners. Water and dirt can get into the shock and damage it!
•
Remove all visible, dried dirt from the area of the wiper seal. This will prevent dirt from getting into
the shock.
•
It is not necessary to grease the shock in the area of the wiper seal.
•
After cleaning, lubricate the sliding surface of the remote lever on the handlebar.
3.3 SERVICE INTERVALS
If service intervals are not respected, any warranty claims can be denied.
Task
Small Service
Full service carried out by a DT Swiss service center
Check the shock for damage
Check the fastening is correct
Check the functionality
Clean with a soft sponge and a suitable cleaning
agent, especially in the area around the wiper seal.
Do not use high pressure cleaners or aggressive
cleaning agents!
Interval
• intensive use: 40 operating hours
• normal use: 100 operating hours
• or as required
Annually or after 200 operating hours
Before and after each ride
Before each ride
Before each ride
After each ride
R 535 ONE Technical Manual V2021.10
7
Advertisement
