DT SWISS R 535 ONE Technical Manual page 16

8. Slightly grease the inner surface of the air
chamber housing and the thread. Grease the
wiper seal generously.
→ Required grease, see table "Required
Material" on page 9.
9. Clamp the shock into the vice.
10. Slide on the air chamber and tighten it by hand.
→ Ensure, that the O-ring and the support ring
does not get jammed.
11. Take the shock out of the vice.
12. Put the SAG O-ring onto the oil chamber.
Closing steps.
Mount the shock hardware.
Mount the shock.
16
Link
GREASE