DT SWISS R 535 ONE Technical Manual page 12

REPLACING THE O-RING OF THE AIR CHAMBER, QUAD-RING AND SUPPORT RING
Only shock with trunnion mount:
1. Remove the O-ring from the air chamber.
2. Clean the seat of the O-ring on the air chamber.
3. Slightly grease the new O-ring and fit it onto the
air chamber.
Only shock with standard mount:
1. Remove the O-ring from the air chamber cap.
2. Clean the seat of the O-ring on the air chamber
cap.
3. Check the air chamber cap for damages in the
area of the O-ring.
4. Slightly grease the O-ring and put it back onto the
air chamber cap.
5. Remove both support rings from the oil chamber
tap.
6. Remove the quad-ring from the oil chamber tap.
7. Clean the seat of the quad-ring and the support
ring,
8. Slightly grease the new quad-ring and fit it onto
the oil chamber tap.
→ Ensure that the quad-ring is not twisted.
12