Advertisement
MOUNTING THE DU-PIN
1. Slightly grease the inner surface of the DU
bushing and the outer surface of the DU pin.
2. Push in the DU pin by hand.
3. Position the pin centrally by clamping the pin in
the vice and while turning the shock, pushing it to
the center.
4. Wait a few minutes and check the DU bushing
again (see "Testing the DU bushings" on page
18).
If this test fails a second time, contact a DT Swiss
service center.
MOUNTING THE SLEEVE
1. Slightly grease the DU pin.
2. Slide the O-rings onto the sleeves.
Closing Steps
Dispose all waste in an environmentally compatible
manner.
Assemble the shock to your bicycle.
Link
"1.6 Environmental protection" on page 4
R 535 ONE Technical Manual V2021.10
GREASE
GREASE
21
Advertisement
