Advertisement
6.
ATTACHING THE REMOTE CABLE
1
2
1. Insert the cable housing (1) into the remote lever on the handlebars and into the cable adjuster (2)
on the shock.
→ Only use cable housings with an outer diameter of 4 mm.
→ The cable housing must be long enough to allow the handlebars to turn fully in both directions.
The shock and other components must function properly at all times.
2. Switch the remote lever to the "OPEN" position and route the cable (4) through the cable housing
(1).
3. Place the cable (4) around the remote wheel on the shock and clamp it using the clamping screw
(3). When tightening the clamping screw, do not exceed a tightening torque of 1.3 Nm.
4. Shorten the cable housing (4) and press on the cable end crimp (5).
5. Switch to "DRIVE" mode using the remote lever and adjust the cable tension.
→ Shock with standard mount: The "DRIVE" marking (7) on the remote wheel must face the stop
screw (6).
→ Shock with trunnion mount: The "DRIVE" marking (8) on the remote wheel must face the valve.
6. If necessary, adjust the cable via the cable adjuster (2) until both markings are correct.
24
3
4
5
6
7
8
Advertisement
