Maintenance And Care - DT SWISS TUBELESS READY KIT User Manual

5. INFLATING THE TIRE
1. Inflate the tire quickly to the lower maximum pressure of either the rim or the tire.
2. Check if the tire is seated correctly.
→ The tire must contact the rim evenly around its entire circumference. If not, release the air, push
the tire back into the rim bed and start the procedure again.
→ Have the tire seat checked by a professional if in any doubt.
3. Slowly rotate and shake the wheel to spread the tire sealant to the whole inner surface of the rim and tire.
4. After the tire is tight, reduce the pressure to your own requirements.
5. Perform a short test ride and check the tire pressure regularly.
6.

MAINTENANCE AND CARE

Task
Check the sealing fluid regularly in accordance with the manufacturer's specifications
and change it if necessary.
Check the Tubeless Ready Tape.
The Tubeless Ready Tape needs to be changed
when
• the imprint comes off and the amber
carrier material is visible (see figure)
and / or
• strong bulges at the spoke holes are
visible inwards and the tape wrinkles
strongly at the spoke holes (see figure).
DT Swiss recommends to change the tubeless ready tape every 12 months.
14
Interval
as required
3 months