Service And Care - DT SWISS F 535 ONE Technical Manual

2. SERVICE AND CARE

2.1 SAFETY
DANGER
RISK OF INJURY DUE TO WRONG MAINTENANCE OF THE FORK!
Incorrect maintenance or assembly of the fork can lead to incorrect function!
• Maintenance and assembly may only be done by a skilled professional.
• In case of any doubt, contact a DT Swiss service center.
• Only use original spare parts.
2.2 SERVICE INTERVALS
If service intervals are not respected, any warranty claims can be denied.
Task
Full service carried out by a DT Swiss service center
Small service (see "4. Small Service" on page 7)
Check fork for damage and cracks.
If there is any damage, contact the DT Swiss Service Centre.
Check the fastening is correct / check tightening torques
Check the functionality
Care (see below)
2.3 CARE AND CLEANING
The following care and cleaning instructions must be observed:
• Clean the fork with a damp cloth after each ride. Remove dirt accumulations in the area of the wiper
seals.
• Never use aggressive cleaners that damage the wiper seals.
• Do not use high-pressure cleaners. Water and dirt can get into the fork and damage it!
• Remove all visible, dried dirt from the area of the wiper seals. This will prevent dirt from getting into
the fork.
• Additional lubrication of the fork in the area of the wipers from the outside is not necessary.
F 535 ONE Technical Manual V2021.11
Interval
Annually or after 200 operating
hours
50 operating hours
more frequently in case of
extreme operating conditions.
Before and after every ride
and after a crash
Before each ride
Before each ride
After each ride
5