Figure 4-3. Power/Alarm Connector; Figure 4-4. Power/Alarm Connector Installed - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Total Access 300 Series Active Ethernet Single Family Unit ONT Installation and Maintenance Guide
5. Tighten the retaining screws.
6. Reinstall the Power/Alarm Connector in the Electronics Module.
7. Tie wrap and route these wires as shown above. This will prevent the connector from
4-8
Back of Electronics Module
7 6 5 4 3

Figure 4-3. Power/Alarm Connector

Back of Electronics Module
Note: Even though there are brackets to
position the Power/Alarm Connector wires,
ADTRAN recommends not using them.
Use of these brackets can "bind" the wires
when the Electronics Module is closed.

Figure 4-4. Power/Alarm Connector Installed

coming loose when the Electronics Module is closed.
2 1
4
7 6 5 3 2 1
Power/Alarm
Connector
7 6 5 4 3 2 1
Power/Alarm
Connector
Tie Wrap wires
as shown
612877AEONT-5B