Description; Safety And Regulatory Compliance - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Total Access 300 Series Active Ethernet Single Family Unit ONT Installation and Maintenance Guide

Description

The Total Access 300 Series SFU Indoor ONTprovides telephone and Internet access for a
single subscriber.
The Total Access 324E ONT supports POTS and Gigabit Ethernet interfaces. In addition, the
Total Access 324E (P/N 1287737G2) has a connection for UPS.

Safety and Regulatory Compliance

For a list of the Safety and Regulatory Compliance Notices specific to individual ONTs, refer
to the
!
WARNING
■ Read all warnings and cautions before installing or servicing this
equipment.
■ Refer to the national, state and local electrical codes for the requirements
for power and grounding wiring methods.
■ The protective earth (PE) grounding wire for this product must be 6 AWG
(13.3 mm
used in conjunction with an anti-rotation device. The connector must be a
suitably approved ground wire connector.
C
CAUTION
This product uses a Class 1 Laser module that complies with 21 CFR 1040.10
and 1040.11 and IEC 60825-1 and -2. For continued compliance with the above
standards, only approved Class 1 laser modules from an ADTRAN approved
vendor list located on the ADTRAN website should be installed in this
product. ADTRAN cannot certify system integrity with other laser modules.
!
CAUTION
■ Electrostatic Discharge (ESD) can damage electronic modules. When
handling modules, wear an antistatic discharge wrist strap to prevent
damage to electronic components. Place modules in antistatic packing
material when transporting or storing. When working on modules, always
place them on an approved antistatic mat that is electrically grounded.
2-2
"Related Online Documentation Resources"
2 ) copper and utilize either a two-hole or a one-hole lug that is
C A U T I O N ! C A U T I O N
SUBJECT TO ELECTROSTATIC DAMAGE
HANDLING PRECAUTIONS REQUIRED.
section in the "Introduction".
OR DECREASE IN RELIABILITY.
612877AEONT-5B