Table 3-4. Ethernet Cable Pin-Outs - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Ethernet Connection
When supporting Gigabit operation (10/100/1000) use a CAT-5e or greater rated cable.
To connect Ethernet, complete the following steps:
1. Route the Subscriber Ethernet wires through the cable entry on the bottom of the enclo-
2. Strip back the jacket of the subscriber Ethernet cable and connect the 4 pair twisted wires
Ethernet RJ-45 Pin-out
Pin
1
2
3
4
5
6
7
8
3. Insert the RJ-45 connectors for each line.
Refer to
612877AEONT-5B
sure. A tie wrap point is provided for wire management (see
to the RJ-45 Plug using a RJ-45 crimper. There are four RJ-45 jacks available in the
enclosure (see Figure 3-20
Pin-Outs.

Table 3-4. Ethernet Cable Pin-Outs

Name
TRD0+
TRD0-
TRD1+
TRD2+
TRD2-
TRD1-
TRD3+
TRD3-
Figure 3-20 on page 3-30 for an example of the final installation should look like.
Section 3, Single Family Unit Outdoor Installation - Installation
on page 3-30). Refer to Table 3-4
Description
Transmit/Receive Positive
Transmit/Receive Negative
Transmit/Receive Positive
Transmit/Receive Positive
Transmit/Receive Negative
Transmit/Receive Negative
Transmit/Receive Positive
Transmit/Receive Negative
Figure 3-20 on page 3-30).
for a list of Ethernet Cable
Color Code
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
3-31