Mount The Ont; Figure 2-1. Ont Indoor Wall Mount - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Total Access 300 Series Active Ethernet Single Family Unit ONT Installation and Maintenance Guide

Mount the ONT

Place the ONT on any flat surface away from direct sunlight. The ONT should be close to an
AC outlet and the fiber entering the customer premises. Mount below eye-level so the LEDs
are visible.
The ONT can also be wall mounted. To mount the ONT on a wall, refer to
complete the following procedures:
1. Attach a 3/4" mounting board (typically plywood) to the wall using four, 2 1/2" or
2. Install two #8 Pan Head screws (1" or greater in length) approximately 5" apart. Use the
3. Slide the ONT over the Pan Head screws and exert a small amount of downward
2-4

Figure 2-1. ONT Indoor Wall Mount

greater wood screws. Ensure the mounting board is supported by wall studs. This pro-
vides long term support for the ONT.
two key holes on the back of ONT as location marks. Leave approximately 1/4"
protruding from the mounting surface.
pressure to ensure that the top of the slots are resting on the shafts of the pan head
screws.
Figure 2-1 and
612877AEONT-5B