Planmeca ProX Technical Manual page 65

13.Attach the Ethernet cable to the drawing tool with a cable tie. Attach the cable from the
cable sheath, NOT from the connector (see figure below).
14.Turn the tube head support as shown on the figure below. Route the Ethernet cable
through the support frame. Push the cable at the same time as you pull it. Remove the
Ethernet cable from the drawing tool and attach the arm cable to it so that the cable tie is
on the cable sheath. Route the arm cable through the tube head support.
Technical manual
Ethernet cable
Cable tie
10 PARTS REPLACEMENT & REPAIR
Drawing tool
Planmeca ProX 63