Greasing - Kubota ZG327A Operator's Manual

If serial numbers of mower are as indicated below
RCK60P-327Z:40001 and above
1. Park the machine on a flat surface and lower the
mower to the ground.
To check the oil level, loosen the oil inlet plug with
gauge, wipe it clean, reinstall it and loosen it again.
Check to see if the oil level is between the notch and
tip.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
2. After checking, reinstall the oil inlet plug with gauge
securely.
(1) Drain plug
(2) Oil inlet plug with gauge
(3) Seal washer
(4) Gear case
(A) Oil level is acceptable within
this range.
(B) Oil level
PERIODIC SERVICE
BGreasing
To avoid personal injury:
A Be sure to stop the engine and remove the key
before greasing.
Apply a small amount of multipurpose grease to the
following points every 50 hours:
If you operated the machine in extremely wet and muddy
conditions, lubricate grease fittings more often.
(1) Front axle (LH, RH)
(2) Front wheel (LH, RH)
(1) Parking brake lock pedal
53