Checking Gear Box Oil Level; Greasing - Kubota G23-2 Operator's Manual

54 PERIODIC SERVICE
BChecking Gear Box Oil Level
To avoid personal injury:
A Always stop the engine and remove the key
before checking oil.
1. Park the machine on a flat surface and lower the
mower to the ground.
To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
(1) Oil level dipstick
A Check the oil level of the transmission case with the
mower lifted up.
A If oil level is low, do not run the engine.
(A) Oil level is acceptable within
this range
BGreasing
To avoid personal injury:
A Be sure to stop the engine and remove the key
before greasing.
Grease the following locations.
(1) Front axle (King pin)
(1) Front axle (Center pin)