BCleaning Engine Shroud Panel
If you feel you are unable to make the following service
correctly and safely, contact your local KUBOTA Dealer.
To avoid personal injury:
A Make sure the engine is cool enough to touch
before
removing
components.
A Always shield eyes and a face from air deposits
and objects.
1. Stop the engine and apply the parking brake.
2. Open the hood.
3. Loosen two screws (right & left) and remove the fan
covers.
(1) Fan cover
(2) Screw
4. Loosen four M6 bolts (right & left) and remove the
cover.
(1) Cover
(2) M6 bolt
shrouds
and
other
PERIODIC SERVICE
5. Remove large debris around the cooling fin and then
blow off small debris with a compressed air. Pressure
of compressed air must be under 205 kPa (2.1 kgf/
cm , 30 psi).
(1) Cooling fin
6. Blow off the debris inside the fan cover as shown in the
figure. Pressure of compressed air must be under 205
kPa (2.1 kgf/cm , 30 psi).
(1) Fan cover
57