Replacing Fuel Filter; Every 500 Hours; Adjusting Engine Valve Clearance; Every After 1000 Hours - Kubota ZG327A Operator's Manual

72 PERIODIC SERVICE
(1) Oil filter
6. Apply a slight coat of oil onto the gasket of new filter.
7. Tighten the filter quickly until it contacts the mounting
surface. Tighten filter by hand an additional 1/2 turn
only.
8. After the new filter has been replaced, the
transmission fluid level normally lowers a little. Add
fluid to proper level. Check for oil leaks around filter
gasket.
9. Return the bottom dust cover to the original position.
A To prevent serious damage or premature failure to the
hydraulic system, use only a KUBOTA genuine filter.
BReplacing Fuel Filter
Consult your local KUBOTA Dealer for this service.
(2) Gasket

EVERY 500 HOURS

BAdjusting Engine Valve Clearance
If you do not have the proper tools and/or are not
mechanically proficient, consult your local KUBOTA
Dealer for this service.

EVERY AFTER 1000 HOURS

BCleaning Combustion Chamber
If you do not have the proper tools and/or are not
mechanically proficient, consult your local KUBOTA
Dealer for this service.

EVERY 1000 HOURS or EVERY 1 YEAR

Replace every 1000 hours or every 1 year whichever
comes faster.
BReplacing Air Cleaner Primary Element
and Secondary Element
(See "Cleaning Air Cleaner Primary Element" in "EVERY
100 HOURS" in "PERIODIC SERVICE" section.)
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
[How to remove the secondary element]
1. While turning slightly, pull out the secondary element.
(1) Secondary element