Battery Troubleshooting; Machine Troubleshooting - Kubota ZG327A Operator's Manual

92 TROUBLESHOOTING

BATTERY TROUBLESHOOTING

Symptom (If)
Starter does not function.
From beginning starter
does not function, and
lights soon become dim.
When viewed from top,
the top of plates look
whitish.
Recharging is impossible.
Terminals are severely
corroded and heat up.
Battery electrolyte level
drops rapidly.
If you have any questions, contact your local KUBOTA Dealer.

MACHINE TROUBLESHOOTING

Symptom (If)
Machine operation is not
smooth.
Machine dose not move while
engine is running.
Machine moves when motion
control levers are in "NEUTRAL
LOCK" position.
(Engine is operated.)
If you have any questions, contact your local KUBOTA Dealer.
Cause
A Battery overused until
lights are dim.
A Battery has not been
recharged.
A Poor terminal
connection.
A Battery life expired.
A Insufficient charging.
A Battery was used with
an insufficient amount
of electrolyte.
A Battery was used too
much without
recharging.
A Battery life expired.
A Poor terminal
connection.
A There is a crack or pin
holes in the electrolytic
cells.
A Charging system
trouble.
Cause
A Hydrostatic transmission fluid is
insufficient.
A Filter is clogged.
A Parking brake is on.
A Transmission fluid
insufficient.
A Hydrostatic lever linkage is not
correctly adjusted.
A Control linkage pivots are sticking.
Remedy
A Charge battery A Charge the battery properly.
sufficiently.
A Clean the terminal A Keep the terminal clean and
and tighten securely.
A Renew battery.
A Charge battery A Battery must be serviced
sufficiently.
A Add distilled water A Regularly
and charge the
battery.
A Charge battery A Charge the battery properly.
sufficiently.
A Replace battery.
A Clean the terminal A Keep the terminal clean and
and tighten securely.
A Replace battery.
A Contact your local
KUBOTA Dealer.
A Replenish oil.
A Replace the filter.
A Release the parking brake.
level is A Replenish oil.
A Ask your dealer for hydrostatic lever
linkage
adjustment.
A Full up and lubricate linkage.
Preventive measure
tight.
Apply grease and treat with
anti-corrosives.
properly before initial use.
check the
electrolyte level.
tight.
Apply grease and treat with
anti-corrosives.
Remedy
adjustment or pressure