Replacing Hydraulic Oil Filter - Kubota ZG327A Operator's Manual

(1) Drain plug
(2) Rear axle gear case LH
(1) Oil level dipstick
(2) Oil plug and breather cup
(A) Oil level is acceptable
within this range.
PERIODIC SERVICE
BReplacing Hydraulic Oil Filter
To avoid personal injury:
A Be sure to stop the engine and remove the key
before changing the oil filter.
A Allow transmission
sufficiently; oil can be hot and may cause
burns.
1. The oil filter must be changed every 400 service hours.
2. To drain the transmission oil, place oil pan underneath
the transmission case and the rear axle gear case
(RH&LH) and remove the drain plug at the bottom of
the transmission case and the rear axle gear case
(RH&LH).
3. After draining, reinstall the drain plugs.
4. Open the bottom dust cover by hand and lock it by
loosening the restraining bolt.
(1) Bottom dust cover
(2) Restraining bolt
5. Remove the oil filter by using the filter wrench.
(1) Oil filter
(2) Restraining bolt
71
case to cool down
(A) "LOOSEN"