Replacing Transmission Oil Filter; Check Points Of Every 50 Hours; Greasing - Kubota WSM BX1880 Workshop Manual

2. GENERAL
4. Tighten filter by hand an additional 1/2 turn only.
5. After the new filter has been replaced, the engine
oil normally decreases a little. Make sure that the
engine oil does not leak through the seal and be
sure to check the oil level on the dipstick.
6. Fill the engine with the engine oil up to the
prescribed level.
7. Properly dispose of the used engine oil.
(1) Engine oil filter
RELATED PAGE
1.1 Lubricants, fuel, and coolant on page 2-7

1.3.3 Replacing transmission oil filter

WARNING
To avoid serious injury or death:
• Be sure to stop the engine before changing the
transmission oil filter cartridge.
• Oil can be hot and can burn. Allow the engine to
cool down sufficiently.
IMPORTANT
• To prevent serious damage to the hydraulic
system, use only a KUBOTA genuine filter.
1. Remove the transmission oil filter.
2. Put a film of clean transmission oil on rubber seal of
new transmission oil filter.
3. Tighten the transmission oil filter quickly until it
contacts the mounting surface.
4. Tighten the transmission oil filter by hand an
additional 1/2 turn only.
5. After the new transmission oil filter has been
replaced, the transmission fluid level will decrease a
little. Make sure that the transmission fluid does not
leak through the seal, and check the fluid level.
6. Check the dipstick and refill with oil to prescribed
level.
7. Properly dispose of used oil.
2-24
(1) Filter

1.4 Check points of every 50 hours

1.4.1 Greasing

• If the machine is operated in extremely wet and
BX1880,BX2380,BX2680,RCK60B-23BX,RCK54-23BX,RCK48-18BX,RCK60D-26BX,RCK54D-26BX
CHECK AND MAINTENANCE
RELATED PAGE
1.1 Lubricants, fuel, and coolant on page 2-7
NOTE
muddy conditions, lubricate grease fittings
more often.
1. Periodic service
KiSC issued 03, 2019 A