Kubota ZG327A Operator's Manual page 32

12 OPERATING THE ENGINE
3. Make sure that the PTO lever is in the
"DISENGAGED" (OFF) position.
(1) PTO lever
4. Place the motion control levers in the
"NEUTRAL LOCK" position.
(1) Motion control lever (LH)
(2) Motion control lever (RH)
"ENGAGED" (ON)
"DISENGAGED" (OFF)
(A) "NEUTRAL LOCK"
Position
(B) "NEUTRAL" Position
(C) "FORWARD"
(D) "REVERSE"
5. Set the throttle lever as follows.
A If the engine is cold:
Pull the choke knob out.
A If the engine is warm:
Place the throttle control lever midway between the
"SLOW" and the "FAST" positions.
(1) Throttle lever
(2) Choke knob
(A) Pull out: "ON" position
(B) Push in: "OFF" position
6. Insert the key into the key switch and
turn clockwise one notch.
Make sure the Easy Checker (TM) lights
are ON.
A Do not depress the hydraulic lift control pedal.
When the engine is off, depressing the hydraulic lift
control pedal (UP or DOWN) will lower the implement.
7. Turn the key switch to the "START"
position and release the key to the "ON"
position when the engine starts.
A Because of the start interlocks, the engine can not be
started except when the PTO clutch is disengaged
(OFF), the parking brake lock pedal is applied, motion
control levers are in "NEUTRAL LOCK" position and
the operator is sitting on the seat.
"FAST"
"SLOW"