4: Cross Input Zones; 5: On-Board Relays; 6: System Settings; 7: Timers - Honeywell NOTIFIER RP-2002C Instruction Manual

Read Status
4.15.4 Cross Input Zones
Pressing 1 while viewing Read Status Screen #2 will display the following screens:
READ STATUS
1=CROSS INPUT ZONES
Press 1 for Release Circuit 1 or 2 for Release Circuit 2. A screen similar to the following will be
2=ON-BOARD RELAYS
3=SYSTEM SETTINGS
displayed:
Read Status Screen #2
The Cross Zones Release screen displays the zones that have been cross-zoned. In this example,
Zone 1 is cross-zoned with Zone 4.
4.15.5 On-Board Relays
Pressing 2 while viewing Read Status Screen #2 will display the following screen:
To view the information about a relay, press the number key corresponding to the desired relay. The
following screen will be displayed:
4.15.6 System Settings
Pressing 3 while viewing Read Status Screen #2 will display the following screens:
ABORT TYPE
TROUBLE REMIND
CHARGER DISABLE
The operator can view the system settings options that have been programmed into the FACP.
4.15.7 Timers
READ STATUS
1=TIMERS
Pressing 1 while Read Status Screen #3 will display the following screens:
2=DAYLIGHT SAVINGS
3=HISTORY
Read Status Screen #3
These screens allow the operator to view the various timer settings.
RP-2002 Series Manual — P/N 53039:E6 1/26/2017
SYSTEM SETTINGS
UL
NO
NO
TIMERS
PRE-DISCHARGE1
PRE-DISCHARGE
DISCHARGE1
CROSS INPUT ZONES
1=RELEASE 1
2=RELEASE 2
Cross Input Zone Screen
CROSS ZONES REL 1
X 1 2
NONE
NONE
Cross Zones Release Screen
ON-BOARD RELAYS
1=RELAY 1
2=RELAY 2
3=RELAY 3
RELAY #
TYPE ALARM
LATCHING NO
SYSTEM SETTINGS
FACTORY BANNER
TIMERS
30S DISCHARGE2
30S WATERFLOW DELAY 90S
1MIN AC LOSS DELAY
Operating Instructions
SYSTEM SETTINGS
CANADIAN OPTION NO
SEC ANN ENABLE NO
1MIN
2HR
89