FarmTek FodderPro Manual page 36

General Growing Tips
Despite the factors that must be addressed before you begin using your
fodder system, these general tips will help you get started:
Water Quality: Clean water is a must. If you can't drink it, don't use it. If
•
you are not sure about the water quality, have it tested.
• Water Temperature: Keep the water temperature constant and in the
range suitable for the seed or grain you are using.
• Quality of the Seed or Grain: While it may cost slightly more, good
quality, clean grain or seed will save time. You won't have to clean the
grain, or worry about foreign objects growing in the fodder that might
pose a danger to your animals if eaten.
Climate Control: A properly maintained environment is a must. Ensure
•
you have controls in place to automatically control temperature and
humidity. Additionally, do not rely solely on automatic equipment;
ensure you are physically monitoring the environment daily and make
adjustments if needed.
• Keep the System Clean: Follow the cleaning guidelines presented in
this guide.
General Guidelines to Promote Optimal Growth
Water Temperature 60° F (minimum) to 75° F (maximum)
pH Level 6.2 - 6.4 (range)
Humidity 40% to 80% (Best in most cases is 60%.)
Ideal Temperature Range 63° F to 75° F
36
Growing Tips and Basic Maintenance
Basic Maintenance
The fodder system requires regular maintenance and cleaning. The duration
between the maintenance and cleaning sessions, however, depends on how
and where the system is used and what seeds are grown. The only way to
determine a regular maintenance and cleaning schedule is to closely monitor
your system once it is fully functioning. A clean fodder system increases
fodder production and reduces loss due to mold and other harmful biological
and environmental factors.
Below are a few suggestions to help maintain and clean the fodder system:
• Check all fittings to ensure there are no leaks. Repair or replace
damaged parts immediately. Seal all leaks when found.
• For best results, clean and disinfect the fodder trays after each harvest.
System is designed so trays can be removed and cleaned. Use a 10:1
mixture (water/bleach) to disinfect the trays when cleaning. Be sure to
rinse thoroughly to remove the cleaning solution before using the trays.
• Store, prepare, and soak seeds in an area that is separate from the
operating fodder system.
112712 Revision date: 09.21.18